Denver, CO · what it costs
What Wolf repairs cost in Denver
Six bands, one flat visit charge, and a page for each job that says which band it lands in and why. Nothing here is an estimate dressed up as a price: a band is where work of that kind sits, and the figure you are given before anything comes apart is the figure you pay.
Parts and labour land between $180 to $910
The visit is a flat $89 — travelling out, plus the whole diagnosis — and it comes off the repair bill the moment you say go ahead.
The question underneath almost every call to this workshop is the same one, and it is rarely "can it be fixed". It is "what am I about to spend, and on what". So the answer is set out before the phone rings rather than after the panel is off.
What moves a bill on dual fuel and steam equipment is not the badge on the door. It is which part failed, whether that part rides on the van or has to be ordered against a model and serial plate, how the unit is built into the cabinetry, and what the fault has already damaged on its way out.
Work with no published band is not guessed at. Descaling a boiler, a water tank that will not release, a warming drawer that has stopped holding temperature — those are quoted once the fault is known, and the page for each of them says so in the same words.
The bands
Six kinds of work, and where each one turns up
- Igniter or spark module the gas half of a dual fuel range, when a burner ticks and ticks before it catches $180to$470
- Burner valve or orifice service a simmer that will not sit low, or a flame that has never been matched to this elevation $240to$560
- Oven thermostat or sensor calibration a cavity that bakes to the wrong number however long you give it $210to$460
- Convection fan or motor a fan that howls, rattles or falls silent while the cavity still heats $300to$650
- Control board or touch panel a panel that has gone dark, frozen or deaf to the pads after a power cut $470to$910
- Door hinge, glass or seal a door that sits proud, drops open, or lets heat out over the top $270to$700
Job by job
A page for each of them
-
Dual fuel burner valve and orifice service cost
A mile above the sea, this band buys set-up as often as it buys a worn part, and from the kitchen side the two jobs look much alike.
-
Wolf control board and touch panel replacement cost
The dearest band on this site, and the one reached for soonest. A panel that went quiet after the power blinked is very often still a working panel, and two minutes at the breaker will say so.
-
What a Wolf convection fan motor costs to fix
A convection cavity moves its heat with fans at the back wall, and the appliance cools its own electronics with another fan behind the trim. Only the first kind reaches this band.
-
Wolf oven door hinge, glass and seal cost
A hinge, a pane and a gasket sit inside one band, because on an oven door they wear as a set rather than one at a time. Before any of it is priced there is a rack question worth asking, and asking it costs nothing.
-
Dual fuel igniter and spark module cost
Sparking hardware is the cheapest band on this site, and a burner that ticks and ticks before it catches is the commonest reason anybody reads it.
-
Wolf oven sensor and calibration cost
One band pays for both halves of this job: the component that reads the cavity, and the offset that corrects what it reads. The half done in your own kitchen, before anybody drives out, is free.
-
The repair bill against a new dual fuel range
The one page here that prints what a new machine costs, because a comparison is only worth reading when both halves of it are on the table.
-
What the flat service call covers
One fixed figure, and an exact list of what it buys. It does not move with the distance, the appliance, or how long the fault takes to corner.
-
What a Wolf steam oven repair costs
A steam oven splits into two bills. The dry half — panel, fan, door — falls in the same published bands as any built-in oven. The water half is quoted once somebody has seen it, and never before.
Ask for the band before the visit rather than after it. Wolf Pro Repair Denver, (720) 649-6641, will tell you which one a symptom usually lands in over the phone, for nothing.
The other half of the question is which part actually failed. The parts pages take the six that fail most on this equipment and say what each one does, how it goes, and which band above it lands in.
Reviews
What the bill looked like afterwards
Wolf cooking equipment, in and around Denver.
4.9 / 51,583 reviews
Two burners in our narrow Victorian kitchen barely made a flame while the others roared. The regulator had partly failed and was starving the far end. He fitted a new one and rechecked every burner.
Nash V.South Broadway
Steam oven kept asking to be descaled and then refused to run at all. The pump inlet was choked with mineral scale from our water. He flushed it, changed the cartridge and wrote the routine down.
Corbett H.Sloan's Lake
Cooking smells drifted back into the room hours after we had finished. There was no flap in the wall cap at all, and a duct joint had come apart in the soffit. Both fixed, over two visits.
Tobin S.Bonnie Brae
Denver · Wolf only
Tell us the symptom and we will tell you the band
No charge for that part. The visit itself is fixed, and it comes off the repair the moment you approve it.
$89 for the visit, taken straight off the repair once you approve it.